CAD Forums > CAD General

Match mtext formatting in table cells

(1/2) > >>

Dave M:
I have a table that is using Lucida Sans Unicode for the text style.  There is no italics setting to use in the style, but I can go into the mtext editor and select italics.  Is there a way to paint that format to all the cells?  I have tried, but I can't seem to get it to work.


Thanks for looking

Jeff_M:
You can set the style using that font to have an Oblique angle.

Dave M:
Thanks, I should have said that I already tried that, it just doesn't look the same as when I click the italics button in the mtext editor.

Jeff_M:
Dave,if you edit the contents of a single cell, highlight all the text in the cell, the ribbon gives the option to use italics. Click that option and exit the edit. Now select that cell, click and start to drag the lower right grip, rt. click, select fill formatting only, then drag to the end of the column. This image is from me doing these steps and also uses the same font you mentioned.

Dave M:

--- Quote from: Jeff_M on May 15, 2020, 03:52:31 PM ---Dave,if you edit the contents of a single cell, highlight all the text in the cell, the ribbon gives the option to use italics. Click that option and exit the edit. Now select that cell, click and start to drag the lower right grip, rt. click, select fill formatting only, then drag to the end of the column. This image is from me doing these steps and also uses the same font you mentioned.

--- End quote ---


Jeff_M:  This is great! I appreciate the help.  Learn something new everyday!

Navigation

[0] Message Index

[#] Next page