Topic: AutoCAD Match Geometry X,Y,Z

[Matthew H]

Does anyone have a lisp routine that can Match-Properties the geometry properties of a line.
See example picture: "Example_Properties.PNG"

*Match Source Line (Start X, End X) to Destination line.
*Match Source Line (Start Y, End Y) to Destination line.
*Match Source Line (Start Z, End Z) to Destination line.

Normally I copy the Start X, End X of a line and paste it onto the desired line. Same for the Y or Z, Depending on what is needed.

If anyone has a solution to this, I would be much appreciated.

[Mark]

Sorry, don't understand the purpose. Why not just use copy/paste on the line?

[Matthew H]

Sorry, don't understand the purpose. Why not just use copy/paste on the line?

The purpose would be in 3D. If I have a center line of a pipe at the correct X and Z coordinates (Color Green). I would want to line it up with the Y coordinates of another line (Color Red).
To solve this I copy the Y Coordinate of the Red Line onto the Green line's properties. (Keep in mind the Green line will not connect to the Red line)

See example image: "Example.PNG"

[MP]

Leverage .x, .y and .z (.xy etc) point filters ftw.

Edit: See link

[Matthew H]

Leverage .x, .y and .z filters ftw.

MP, I always forget about Point Filters. Ill have to look into them again.

[MP]

The use of point filters can reduce the use of temporary construction lines to near zero.