Author Topic: Problem by boundary between blocks  (Read 33756 times)

0 Members and 1 Guest are viewing this topic.

francinez

  • Guest
Re: Problem by boundary between blocks
« Reply #45 on: May 22, 2015, 09:22:50 AM »
Do you know a way to override this problem? I need a approximativ contour that is possible to hatch

mjfarrell

  • Seagull
  • Posts: 14444
  • Every Student their own Lesson
Re: Problem by boundary between blocks
« Reply #46 on: May 22, 2015, 10:15:49 AM »
not sure if you will be 'allowed' to do this; as I do not know the intended purpose of your drawings

however this appeared to work, and the 'solution' may require this to be done to different components for differing assemblies

However what I did;

set hpgaptol back to 0

took the two outside components, and used the midpoint of that little line @ center of the feature as a base point I scaled the component 1.00000001
this was enough to allow the hatch operation to proceed normally

If yours are not drawings used to manufacture this item it should not cause any harm
Be your Best


Michael Farrell
http://primeservicesglobal.com/

mjfarrell

  • Seagull
  • Posts: 14444
  • Every Student their own Lesson
Re: Problem by boundary between blocks
« Reply #47 on: May 22, 2015, 10:18:51 AM »
one could even resort to  NON ASSOCIATIVE Hatch boundary....

offset your features something like 0.0000001

HATCH

then delete the offset objects
Be your Best


Michael Farrell
http://primeservicesglobal.com/

francinez

  • Guest
Re: Problem by boundary between blocks
« Reply #48 on: May 22, 2015, 11:17:54 AM »
Thank you for your help, I will test your proposition next week.