Topic: Batch Plotting DWG's to Separate PDF's

[M-dub]

I KNOW I've done this umpteen times in the past and I'm sure I've read posts about it, too.  Why can't I figure it out right now?!

I've got to batch plot dozens of drawings to separate pdf's.

[dgorsman]

PUBLISHCOLLATE sysvar and/or multi-sheet setting in the Publish options dialog?

[JohnK]

1) Publish.
    a) Use the "Default" page setup in each layout.
2) Get a cup of coffee.

[JohnK]

PUBLISHCOLLATE ...

AAHHhh!? I was trying to remember that one just last week! Thanx.

[M-dub]

For the love of all things holy!

Thank-you, thank-you, thank-you!

I KNEW this would be a facepalm moment! 

[M-dub]

Lovely!
After bashing my head against the wall over this, I come to find out it was pFD's the guy wanted... not pDF's!

Oh well... I would've come to that problem sooner or later anyway...

[dgorsman]

Lovely!
After bashing my head against the wall over this, I come to find out it was pFD's the guy wanted... not pDF's!

Oh well... I would've come to that problem sooner or later anyway...

  Not the first time I've run into that problem.