Let's see if I can clarify a little. First off, sorry for not getting back sooner, Friday was busy as can be, I'm sure you can relate.
We are running lot closure reports for Platting purposes. We have line work that makes up a Subdivision, right-of-ways, lots, tracts, etc. The easy way (opinion) is to use the "Boundary" command to create each closed Lot. Then define this as a Parcel in LDD. This will generate a report that we check against the Plat Bearings/Distances. For those of us that "nit-pick" (sp?) we would like each parcel to start at say the lower left corner and go in a clock-wise direction. As far as I know, the boundary command does not allow any user input of the starting point of the resulting polyline. Then in the report the Lot would follow in a clock-wise direction and ease the checking process.
Does this help at all, or just clutter things up?
Dan