CAD Forums > Vertically Challenged
Inventor Fonts
Luke:
We are working on getting Inventor 2010 setup. We will continue using AutoCAD 2010 also. Currently my general notes and dimensions in ACAD use ROMANS as the font type.
When I try to set up my text and dimension styles in Inventor ROMANS is way to lightweight.
Is there a way to make the text in inventor print darker?
Romans .08height x 85%width shows up perfect in AutoCAD shows up too light in Inventor.
By the way not sure where to post inventor questions.
mjfarrell:
http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2861661&linkID=9242018
http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2861657&linkID=9242018
Luke:
MJ,
I don't think that is my issue...
In autoCAD I'm using the autocad SHX fonts and they work fine. Inventor is using windows TTF fonts but they (the peticular on I want) show up too faint.
I did not import anything from AutoCAD into Inventor. I'm starting inventor from scratch and just comparing it to my AutoCAD printed sheet.
mjfarrell:
--- Quote from: Luke on August 24, 2009, 03:05:39 PM ---MJ,
I don't think that is my issue...
In autoCAD I'm using the autocad SHX fonts and they work fine. Inventor is using windows TTF fonts but they (the peticular on I want) show up too faint.
I did not import anything from AutoCAD into Inventor. I'm starting inventor from scratch and just comparing it to my AutoCAD printed sheet.
--- End quote ---
wasn't sure where the two-dee line work was originating, however I thought it might point you towards using different fonts in Inventoer due to those known issues...
Luke:
I follow... so is this saying I can direct Inventor to look to SHX fonts?
Navigation
[0] Message Index
[#] Next page
Go to full version