« previous next »
Pages: [1] |   Go Down

Author Topic: what happened to my model?  (Read 2974 times)

0 Members and 1 Guest are viewing this topic.

Big G

  • Bull Frog
  • Posts: 415
what happened to my model?
« on: June 17, 2008, 10:06:35 PM »
was drawing a (small) 3d pipework when the inevitable happened and i fatal errored  :pissed:....Im not entirely sure whats happened but the shaded VP doesnt display all the parts of the pipe network where it did before!

Im not MASSIVELY into 3d and its even stumped a few other lads in the office here!

Any ideas/pointers would be extremely helpful!

slainte!
G
Logged
I thought i seen the light at the end of the tunnel. But it was just someone with a torch bringing me more work.
"You have to accept that somedays youre the pigeon and  somedays youre the statue"

Guest

  • Guest
Re: what happened to my model?
« Reply #1 on: June 18, 2008, 08:08:26 AM »
Purge, Audit, Recover?

Can you post the drawing?
Logged

t-bear

  • Guest
Re: what happened to my model?
« Reply #2 on: June 18, 2008, 01:56:11 PM »
Not sure what you're designing in...2K4 here.  If you're in "regular" acad, try these settings:

 "dispsilh"=1
"hideprecision"=1

These determine the look of solids, especially cylinders, when you hide your model.
Logged
Pages: [1] |   Go Up
« previous next »