dont ask. I have just taken over as CAD manger, to find:
a: They are using 2002 even though they are paid up to use 2007!
b: Copy and paste was taken out.
c: No access to Cute PDF
d: This VB script runs every time you open a drawing and resets things like osnaps, regenauto, grid etc etc.
e: SDI is turned ON!
the list goes on........do you have an hour? i would be going off on a rant if i kept going. I am new here so i need to pick my battles at the moment. firstly i need to restore order. then i need to go about dragging this lot into the 21st century. they were using release 14, yes 14, until about 2 years ago. they only reason they are changing is because the cad manager before me is gone of to work for the gestapo or sombody like that, and i would only take the job if i could straighten the place out.