TheSwamp

CAD Forums => Vertically Challenged => Land Lubber / Geographically Positioned => Topic started by: Mark on September 29, 2005, 11:58:28 AM

Title: ( C3D ) CGang command output
Post by: Mark on September 29, 2005, 11:58:28 AM

Looks like it may be a bug!!

Title: Re: ( C3D ) CGang command output
Post by: Bob Wahr on September 29, 2005, 02:54:07 PM

I had images of bands of Gangsta C Programmers running around.

Title: Re: ( C3D ) CGang command output
Post by: Jeff_M on September 29, 2005, 03:44:34 PM

Interesting, Mark! It appears that the CGang function uses the direction the lines were drawn, which is not how this command has functioned in LDD.

Title: Re: ( C3D ) CGang command output
Post by: Mark on September 29, 2005, 03:49:25 PM

The strangest part though is if you move the two lines and run 'cgang' again you get the desired results.  :roll:

Title: Re: ( C3D ) CGang command output
Post by: Jeff_M on September 29, 2005, 04:03:11 PM

Well, sometimes moving them it works. I just tried this with 4 seperate sets of lines. Moving them gave the desired results on 3 sets, but no amount of moving the 4th set gave the correct result. What da ......  :?
I just posted this to the Civil3D newsgroup......let's see what others have to say about this....