TheSwamp
CAD Forums => CAD General => Topic started by: CMU on January 06, 2022, 02:12:04 PM
-
May I ask the system variable that controls the viewport always restoring back to extents when clicking model space of an unlocked viewport?
Any help would be appreciated.
Thank you in advance. :crazy2:
-
UCSFOLLOW I think, that must be off.
-
Thanks for the tip, but unfortunately 'UCSFOLLOW' was not it. :-(
I appreciate the help
-
For clarification huiz was correct. After much experimentation, the issue was the UCSFollows after all. Once it is set to 1 and you place your viewports, you will need to set the UCSFollows in each viewport to 0, for it to take effect. :tickedoff:
Best bet is to set UCSFollows to 0 at start.
Thanks for the help huiz, much appreciated.
CMU