TheSwamp
CAD Forums => Vertically Challenged => Topic started by: MSTG007 on December 19, 2017, 02:33:45 PM
-
I must be drawing a blank. I know I can do this in profile view where it can label the pipe crossing.
I did not know if there was a way via plan view. User selects one pipe and then the other and it spits out the inverts or what not.
thanks!
-
I must be drawing a blank. I know I can do this in profile view where it can label the pipe crossing.
I did not know if there was a way via plan view. User selects one pipe and then the other and it spits out the inverts or what not.
thanks!
There's a few apps in the exchange for this.