TheSwamp
CAD Forums => Vertically Challenged => Land Lubber / Geographically Positioned => Topic started by: PHX cadie on October 31, 2017, 10:21:37 PM
-
I have an alignment that basically runs north-south. I've used the company label style, but since we are starting on the north end I need the text rotated 180 about the tick. I've tried every multiple of 90 degrees in the rotation angle, but its always the wrong way or perp with the align. The preview is what I would like, but my stationing is 180 out
What am I doing wrong?
hope the attach is not super huge :(
(my 1st "company" C3D)......Arrrrrrr
-
Look at the other GENERAL TAB and check to see if your label is set to be Plan Readable
also verify its Anchor Point and Anchor Component
-
Plan Readable :)
Thank u Sir!