TheSwamp
CAD Forums => CAD General => Topic started by: dubb on September 15, 2017, 07:27:45 PM
-
I want to represent the top and toe of a ditch. Does anyone know if my symbol is correct. Image attached.
-
Thats what I would use know as a tadpole.
Here is a batter tick program
-
I want to represent the top and toe of a ditch. Does anyone know if my symbol is correct. Image attached.
They are backwards....typically the triangle points to the bottom of the slope
in your example it appears to point up from the bottom of the slope.
-
Thanks for the tip.
I want to represent the top and toe of a ditch. Does anyone know if my symbol is correct. Image attached.
They are backwards....typically the triangle points to the bottom of the slope
in your example it appears to point up from the bottom of the slope.