TheSwamp
CAD Forums => CAD General => Topic started by: dpatterson on August 08, 2016, 11:41:20 AM
-
Hi Everyone,
I was hoping I could get some help. I built a simple corridor along an alignment, but when i create a surface from the corridor and check the elevations at each station they are off? They do not seem to be off by a constant value. Is there a way to make the corridor model the profile alignment closer or correct this issue.
For example: station 100 profile = 95.054
station 100 corridor surface check = 94.680
It should be equal to profile.
Thanks for your Help!
_David
-
David, can you post your dwg file? If not, double check the objects which make up the surface, make sure the subassemblies aren't offset from the assembly insertion, etc.