TheSwamp

CAD Forums => CAD General => Topic started by: pmvliet on December 10, 2003, 12:13:01 PM

Title: structural bar joists lisp?
Post by: pmvliet on December 10, 2003, 12:13:01 PM
For any structural people out there, do you have a lisp routine to draw
truss's in elevation. meaning so you see the diagonals like a VVVVVV.
I use to have one that you selected start point, end point and depth and you were done. I have one called kjoist.lsp and comes with a dcl. I can't get it to work nor do i know if this is the one I used. Been a few years.

Thanks,
Pieter