TheSwamp
CAD Forums => CAD General => CAD Standards => Topic started by: MSTG007 on August 18, 2004, 08:49:20 PM
-
We are in the middle of trying to come up with a new design per our title blocks.
Just trying to get ideas and what looks good to the client.
Ill post ours later... but we usually have all our info on the right side of the title block...
-
Here (http://theswamp.org/lilly.pond/fuccaro/indic.gif) is ours. It is a simple one. I colored the attributes. The file name and the data are Diesel expressions.
-
This one (http://theswamp.org/lilly.pond/Bear/T-Block1.jpg) is for our D-size prints. It's attributed for ease of editing....simple but sweet.
-
Does anyone have any architectural titleblock examples? I am trying to get together some stuff on the side and start doing residential work at home. I have come up with a few different designs, but nothing that wows me.
-
Very professional looking guys.
This thread belongs in the new forum.
Ooops it hasn't been created yet. 8)
Just kidding around, Mark.
-
Which new forum? I was just thinking it should be in Cad Standards. It has that feel to it.
-
That's what I was thinking , Daron. :)
-
done
-
My title block is rather simple:
I do have some Rtext at the left as a Plot Stamp.
The sheet title and job name are to the right, out of view.
I make these large for easy identification of the sheet.
And the Owner like to see the name in Large Bold Print. :)
(http://www.theswamp.org/lilly.pond/CAB/TitleBlock.png)
-
Ours is on the right, with attributes for quick editing.
I was contemplating a change, to Xref the title sheet in and just use a block for the attributes only. Would help to keep the drawing sizes down. Plus any changes to the title block would be instantaneous throughout.
-
Hmm, me thinks Fuccaro needs to run a spell checker on his title block..
-
If its an Architectural title block that you ara after, try this for size. All of the infills are attributes.
http://theswamp.org/lilly_pond/42/title.pdf?nossi=1