TheSwamp
Code Red => AutoLISP (Vanilla / Visual) => Topic started by: zemleroi on May 25, 2007, 05:35:47 PM
-
Hello!
I would like to build a curve (a spline preferably) from radius of curvature measurements stored as a spreadsheet. Radius of curvature measurements are given for points at specified horizontal distances from the start point of the curve.
Do you know of a way to do this? Or is this at all possible in AutoCAD?
-
There is not clearly enough for me
(I am really old stumb though)
Can you upload here a small
picture with some explanations?
~'J'~