CAD Forums > CAD General
identify parallel lines
MSTG007:
BTW how's your day job going?
ronjonp:
--- Quote from: MSTG007 on August 14, 2017, 04:07:03 PM ---
BTW how's your day job going?
--- End quote ---
;D
MSTG007:
lol. Not sure how to respond to that one. That is one LARGE ninja.
Bryco:
quickselect can also tell you this.
r-click in empty part of drawing ->Quickselect->object type->line->angle->value= 90->ok
works like a charm
ronjonp:
--- Quote from: Bryco on August 17, 2017, 11:25:07 PM ---quickselect can also tell you this.
r-click in empty part of drawing ->Quickselect->object type->line->angle->value= 90->ok
works like a charm
--- End quote ---
This is another way, but only works with lines. The code above will work with plines too :)
Navigation
[0] Message Index
[*] Previous page
Go to full version