Code Red > AutoLISP (Vanilla / Visual)

Updating multiple block definitions

(1/2) > >>

ELOQUINTET:
Hey guys,

I've created many blocks in a drawings and have nested those blocks inside of assemblies. Now I found out I need to add another attribute to them. I updated the block but the previous insertions did not update. Take a look at the attached drawing. I need to update the top 2 blocks to include the X attribute like the bottom one. Maybe I'm just having a brain fart this morning but how can I update the existing blocks?

VovKa:
_battman
choose block name then press 'Sync'

ELOQUINTET:
I don't think I worded it right. All of the blocks contain the attribute but what I'm really after is that I want the attribute to be visible which it is not unless I reinsert it. I think I need to reinsert all the blocks where they are now. Does that make anymore sense?

ronjonp:
Dan,

What you are looking for is ATTSYNC.

ELOQUINTET:
ron when i run attsync and select the new (reinserted) block that shows the attribute then select the existing block with the same name i do not see the added attribute?

Navigation

[0] Message Index

[#] Next page