Ok all you pond scum....thats a little higher than the bottom dwellers for all of you lacking sufficient knowledge of a watery ecosystem, we will discuss what an ecosystem is later, it doesn't really matter right now.
What does matter is that I need to put together a program that will open 4000 drawings in succession, spread out in various folders, then remove and replace or redefine a nested block, then remove or rename an existing layer, finally purge any extraneous information and save the drawing. I already have a good start with a program that will open and close all drawings in a specified folder, but what I was wondering is:
Should I attempt to redefine the block within the program or in the interest of widespread usability, should I make a form that asks what block to replace and let the user select an existing block from the hard drive. Either way, I need for this to be hands free after running the program. Since VBA can run across multiple drawings it would be my language of choice.