Topic: Help me speed up existing routine to move objects from Layer 0

[Lee Mac]

You're right - it appears it does - well, that makes my code a lot simpler 

...EDIT: judgin by MP's post, not sure now...

why did you remove the orig code? that would have been a good learning example.

I wouldn't want to leave potentially harmful code to beginners to stumble upon.

[JohnK]

why did you remove the orig code? that would have been a good learning example.

I wouldn't want to leave potentially harmful code to beginners to stumble upon.

whats wrong with commenting out a block of code?

[Lee Mac]

why did you remove the orig code? that would have been a good learning example.

I wouldn't want to leave potentially harmful code to beginners to stumble upon.

whats wrong with commenting out a block of code?

Nothing 

[JohnK]

*sigh* You understand that our goal here at theSwamp is to teach right? ...you know what, never mind.

[MP]

*sigh* You understand that our goal here at theSwamp is to teach right? ...you know what, never mind.

What do you mean by `Challenge'? Do mean to get several people to do this for you so that you can pick the best one or do you mean that you are challenged by this problem. If the later, then there is no need to state that because its obvious by your asking the question.

[cmwade77]

Wow, 2 pages already! Honestly, I learn a lot here, unfortunately I don't always get everything the first time around.

Lee,
As I said, I think it was only harmful in that it might have had characters that are not acceptable in layer names, which would have caused AutoCAD to crash, the VL-Translate *SHOULD* fix that.

[JohnK]

meh