MY UNITS WERE SET TO DECIMAL BUT THAT DOESN'T SEEM TO BE IT. I'VE COPIED MY COMMAND LINE BELOW:
Command: offset
Specify offset distance or [Through] <Through>: 1.25"
Requires numeric distance, two points, or option keyword.
Specify offset distance or [Through] <Through>:
Select object to offset or <exit>:
Specify through point:
Select object to offset or <exit>: *Cancel*
Command:
Command: offset
Specify offset distance or [Through] <Through>: 2.0"
Requires numeric distance, two points, or option keyword.
Specify offset distance or [Through] <Through>:
Select object to offset or <exit>:
Specify through point:
Select object to offset or <exit>:
Command:
Command:
Command: offset
Specify offset distance or [Through] <Through>: 2.25"
Requires numeric distance, two points, or option keyword.
Specify offset distance or [Through] <Through>:
Select object to offset or <exit>:
Specify through point:
Select object to offset or <exit>:
Command: DI
DIST Specify first point: Specify second point:
Distance = 6 1/2, Angle in XY Plane = 0.00, Angle from XY Plane = 0.00
Delta X = 6 1/2, Delta Y = 0, Delta Z = 0
Command:
DIST Specify first point: Specify second point:
Distance = 9 5/32, Angle in XY Plane = 0.00, Angle from XY Plane = 0.00
Delta X = 9 5/32, Delta Y = 0, Delta Z = 0
Command:
DIST Specify first point: Specify second point:
Distance = 7 11/32, Angle in XY Plane = 0.00, Angle from XY Plane = 0.00
Delta X = 7 11/32, Delta Y = 0, Delta Z = 0
HMMM DOESN'T MAKE MUCH SENSE TO ME. IT WORKS FINE IN ALL MY DRAWINGS WHAT'S UP WITH THIS ONE HMMM?
DAN