Hello Bigal,
Would appreciate if you could try it
Thank you very much for your code it works with all my tests so also Test63!
But sadly the zigzags are on the short and not on the long side.
And 1 zigzag/segment is not possible...
just 1 question does it check the rise/run rules for stairs ?
First there is a difference between DCL and OpenDCL...
Yes, i use the formula step-modulus (from my country) and everything is automatic.
When I lower or increase the 15 steps, I see when the staircase is optimal. In the photo, 63.06 cm is bit too high and will be showing in the color red; 15 steps are in this example not 100 % optimal... but still OK of course.
I write the stair data and colors also to a ini file as defaults.
You can see the results in the image but its still work in progress...
This is plain Autocad developed 1990's still available very cheap PM me.
Very nice but I don't use AutoCad for 3D work, the renders aren't realistic enough for me.
I consider myself more has a 3D artist?
Thank you for all
Christina