Thanks
I'm not 100% sure what they want, only that the current method they are using isnt working. They dont seem to like searching on the new model to play "hunt the changes" when their time could be better utilised working out any engineering issues that may appear from changes they might've missed last time out.
As I am also new to full 3D modelling in a shared environment, I had no advice to offer the engineer, and no idea on the "correct procedure" or any alternatives in workflow/efficient practices, so I thought I would ask here.
We have seen Navisworks models on a previous job where we ended up doing 2d on it, and my current project is using Bentley navigator to produce a shared model, but that co-ordinated model is being produced elsewhere, so I have no idea what is involved... to me, this is almost as bad as transferring from drawing board to CAD... just grasping at straws, trying to figure out how we can move forward may form a stumbling block with the "old-skool" engineers who like/want the status-quo