1
AutoLISP (Vanilla / Visual) / Re: Line between 2 endlines
« Last post by FS_AT12 on Today at 03:27:25 AM »dear ribarm,
If the two lines are not parallel, like this situation, I end up with crossing lines.
The 4 points do not appear again.
A big help would be if the connection of the selected lines are part of a closed or open polyline,
so the connection would filter out just the segments of the whole polyline.
Currently, the connection is made from the first and the last vertex of the polyline, somewhere else than the selected segments.
If the two lines are not parallel, like this situation, I end up with crossing lines.
The 4 points do not appear again.
A big help would be if the connection of the selected lines are part of a closed or open polyline,
so the connection would filter out just the segments of the whole polyline.
Currently, the connection is made from the first and the last vertex of the polyline, somewhere else than the selected segments.