TheSwamp
CAD Forums => CAD General => Topic started by: ELOQUINTET on December 16, 2003, 09:07:50 AM
-
hey i just noticed that my autosave was set to 0. what could have caused this to happen yikes!!!
dan
-
Ummmm.............
You changed it?
did you re-install acad by any chance?
-
nope and nope. actually a coworker of mine asked me what he should set his as because it was set to 0. so just out of curiousity i checked mine which was set to 10 minutes and mine was set to 0 as well?
dan
-
Check the acad.mnl and your user.mnl