Hi guys,
I'm kinda newbie when it comes about using VLIDE, and I've been reading some tutorials from Lee Mac's website, about debugging the code.
So my question is: Is it possible to animate only part of the code ?
Say I run first time the code in VLIDE, determine where did the code fail ( using "Last Break Source" ).
Then I watch the variables, and animate the code - to understand exactly why it did fail.
But the problem is:
If the code is very long / or there are subfunctions with long loops, and I set my animation delay for 5 seconds (to analyse more carefully whats happening)
I have to wait like 5-10 minutes, so the animation gets to my desired part, where the failure is located.
And I need exactly this... analyse only part of the code, not the whole code (because I know whats happening elsewhere, except the desired "area").