Unless they are floating dialogue boxes, they; by default center themselves. Add a couple of lines to your code writing a file storing x & y locations. And when lauching the routine, make it read the values to restore position. About 6 months ago I posted some code on the "forum that recently disappeared"!
As an aside, if using ObjectDCL, 't'is done au-to-ma-ti-ca-ll-y!
Hello Serge.
Good to hear from you.
Not sure what a "Floating" dialog box is. Nor how you accomplish the x,y other than what I have done already.
When i launch i set the dialog location via the code line posted above. But because part off the dialog
box is off the screen, ACAD i guess, resets it to center as some sort of error check I guess. If the
box is fully on the screen it will remain in the new location.
To bad about Cadalog, lots of resource material lost. I was wondering if the forum database could be
acquired and archived somewhere for research material. Oh well, we move on to bigger and better things.
CAB
PS
Did you ever solve the Roof Skeleton riddle?