TheSwamp

CAD Forums => CAD General => Topic started by: M-dub on December 02, 2004, 11:06:41 AM

Title: Pipe End Break Symbol
Post by: M-dub on December 02, 2004, 11:06:41 AM

Has anyone got a routine that will draw a decent looking pipe break symbol?
Not two ellipses with one split in half...more like two teardrops with one split in half.  The one guy here insists on using two ellipses and it looks like garbage.  When I show him my way, he doesn't like it because it's "too hard".
I had a look on CADalyst, but couldn't find a decent one.
Thanks a lot!
Mike

Title: Pipe End Break Symbol
Post by: hendie on December 02, 2004, 11:41:56 AM

check out www.resourcecad.com for the TUBEIT routine

don't you know you should look there first !  :twisted:

Title: Pipe End Break Symbol
Post by: M-dub on December 02, 2004, 11:43:30 AM

Sorry Hendie, but I'm not a piper.  The piper is on vacation this week.  (Not that much more gets done when he IS here...:roll:)

Thanks for the tip.

Title: Pipe End Break Symbol
Post by: M-dub on December 02, 2004, 01:45:18 PM

Thanks a lot, Hendie.
Tubeit worked out perfectly.  I'm going to make him a button so he uses it instead of his version from now on.

Thanks again! ;)

Title: Pipe End Break Symbol
Post by: hendie on December 02, 2004, 01:47:26 PM

thanks, I'm glad it was what you were looking for

great site wasn't it ?

Title: Pipe End Break Symbol
Post by: M-dub on December 02, 2004, 02:00:51 PM

'Twas!  I wonder who runs it!

There should be more links to it and reminders about it around here!  ;)

Title: Pipe End Break Symbol
Post by: Keith™ on December 02, 2004, 04:43:05 PM

Quote from: M-dub

'Twas!  I wonder who runs it!

DUH ....  I DUNNO