You're welcome.
Next phase is to allow multiple selections for layers but will likely need to wait till I get back from vacation.
CAB,
Thanks for the help you offered on this LISP, it works great and gets lots of use.
If you have time, do you think you can help me alter it a bit?
I'd like to start with the original LISP, change it's name, and edit a few of it's features.
This is what I'm looking for:
- Keep the same selection feature
- List the blocks current Z-Axis Elevation that is re-definable.
- List the blocks current parameter "Top of Steel".
- List the blocks current parameter "Strut Elev" or "Conduit Elev".
- Take Z-Axis elevation and store the difference from '0' elevation (plus or minus)
- Use difference of Z-Axis and add it to "Top of Steel" & "Strut Elev" or "Conduit Elev" parameters
Reason for all of this is that I have several blocks I've placed at '0' elevation, and based my parameters ("Top of Steel" & "Strut Elev" or "Conduit Elev") of my block based off of '0'. Now the floors have been depressed (ex: -3'-4" AFF) or raised (ex: +0'-3" AFF) and I need to adjust them accordingly--lower a few blocks -3'-4" and then add the 3'-4" to the "Top of Steel" & "Strut Elev" or "Conduit Elev" parameters after doing the math. It's quite tedious, but not the end of the world, like always, just trying to make things easier.
Note: I added some screenshots of my parameters if that helps.
Anything helps.