Say the definition is ALT+E for _ENDPOINT
The cursor actually locks up.
Press ESC and the selection continues with the correct snap set.
too brain dead to have a further look at it tonight
I'm not sure if this is the same problem you are experiencing, but I had a similar problem when I tested on AutoCAD 2009 if the menubar was displayed. The Alt key was trying to activate the pulldown menus. Here is the binary that fixes that bug.
Chuck,
Would you happen to still have the source for this binary? Or could you share what you did to solve the problem. The binary didn't work with my 2011.
Thanks in advance!
Jeff
That fix should be in the latest version (whatever that may be). Kerry (and perhaps others) has made improvements to the code since I last touched it, and I would recommend working from his version rather than anything as stale as the version where that fix was originally made.
If Kerry doesn't want to make his changes publicly available, I will post my most recent source code. Be warned, however, that it doesn't contain any of Kerry's enhancements, and I may have done some playing and left the code in an unstable state. I honestly can't remember what I last did to it, but I know I piddled around with it a little about the time of my last post to this thread.