Author Topic: Elevations with Solids  (Read 1567 times)

0 Members and 1 Guest are viewing this topic.

Murph

  • Bull Frog
  • Posts: 402
  • P.I.T.A.
Elevations with Solids
« on: August 11, 2005, 07:15:54 AM »
Does anyone know how to turn off facets completely on 3d Solids?
I tried DISPSILH at 1 and then nothing showed up.
Murphy's Law applies to all.
Whatever can go wrong, will, and at the most inopportune time.

MP

  • Seagull
  • Posts: 17479
Elevations with Solids
« Reply #1 on: August 11, 2005, 07:36:26 AM »
Try dispsilh at 1 and isolines at 0.
\|// Set goal. Experiment tirelessly until
|Oo| practice has become expertise.  Loop.
|- | LinkedIn | Dropbox

Murph

  • Bull Frog
  • Posts: 402
  • P.I.T.A.
Elevations with Solids
« Reply #2 on: August 11, 2005, 07:46:54 AM »
That did not do it. With DISPSILH at 1 nothing shows up in the elevation.

Further info:
The solids are gas lines from the mech department.
The solids are contained in an xref.
My cabletray is showing up fine but that is and AEC object.
Murphy's Law applies to all.
Whatever can go wrong, will, and at the most inopportune time.