« previous next »
Pages: [1] |   Go Down

Author Topic: Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.  (Read 1826 times)

0 Members and 1 Guest are viewing this topic.

LULU1965

  • Mosquito
  • Posts: 16
Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.
« on: November 23, 2016, 07:21:35 AM »
Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly. The blocks overlapping to itself but bpoly must be single for calculation of waste areas.  Thanks for all help me. excuse for my English.
Logged

didier

  • Newt
  • Posts: 48
  • expatrié
Re: Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.
« Reply #1 on: November 23, 2016, 07:29:20 AM »
Coucou

Do you need a program necessarily?
the command "_bpoly" will will make it very easy

friendly
Logged
eternal beginner ...
my english is not fluent ...

LULU1965

  • Mosquito
  • Posts: 16
Re: Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.
« Reply #2 on: November 23, 2016, 07:31:44 AM »
automatic multiple bpoly (attention rectangle overlapping bpoly not good).
Logged

LULU1965

  • Mosquito
  • Posts: 16
Re: Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.
« Reply #3 on: November 23, 2016, 07:36:20 AM »
The blocks overlap I have to get individual areas including overlapping and bpoly me divide (bpoly multiple but on every single block which is divided into two areas by the red polyline.
Logged

ribarm

  • Gator
  • Posts: 3259
  • Marko Ribar, architect
Re: Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.
« Reply #4 on: November 23, 2016, 07:57:22 AM »
Your blocks overlap... So, you can't use this code :
https://www.theswamp.org/index.php?topic=51605.msg567073#msg567073

Sorry, I can't further guide you... I think that you should only calculate waste, so exploding your blocks twice to lines is my opinion, but result is different than in your posted DWG...
Logged
Marko Ribar, d.i.a. (graduated engineer of architecture)

:)

M.R. on Youtube

LULU1965

  • Mosquito
  • Posts: 16
Re: Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.
« Reply #5 on: November 23, 2016, 08:03:59 AM »
I THINK IS POSSIBLE TO TRANSFORM BLOCKS WITH RECTANGLE POLYLINES.
Logged

ahsattarian

  • Newt
  • Posts: 112
Re: Convert plates blocks to multiple single bpoly (reactor) cut crossing by poly.
« Reply #6 on: September 30, 2022, 02:46:50 PM »
Maybe here  REGION  is the answer.

You can make the left side as a region and also change all pline rectangles into region.

The nbenefit   INTERSECT   commaand to create the common area which seems to be what you need.
Logged
Pages: [1] |   Go Up
« previous next »