CAD Forums > CAD General
LIST command odd behavior
gisdude:
Hi all,
The last day I noticed my LIST command is not LISTING. I type LI and "DS> Highlight Selected Layers <Yes>/No:". I will pick a line or block and it TURNS OFF the layer. WTF? I don't get it.
I looked in the .pgp file and LI does point to LIST. Weird.
Many thank for any help,
ronjonp:
Did you try .list?
gisdude:
Well, that works!
So, this begs my question, how to I change that .LIST to just plain old "LI"?
Dlanor:
--- Quote from: gisdude on November 16, 2018, 11:40:45 AM ---Hi all,
The last day I noticed my LIST command is not LISTING. I type LI and "DS> Highlight Selected Layers <Yes>/No:". I will pick a line or block and it TURNS OFF the layer. WTF? I don't get it.
I looked in the .pgp file and LI does point to LIST. Weird.
Many thank for any help,
--- End quote ---
A more important question is, does something else point to LI later in the pgp file?
ronjonp:
--- Quote from: gisdude on November 16, 2018, 11:53:31 AM ---Well, that works!
So, this begs my question, how to I change that .LIST to just plain old "LI"?
--- End quote ---
Make sure your PGP has this in it:
LI, *LIST
Also check that there isn't another LI definition later in the file as it will override the previous.
Navigation
[0] Message Index
[#] Next page
Go to full version