Author Topic: Progress! flexing elbows  (Read 1021 times)

0 Members and 1 Guest are viewing this topic.

Barry Clark

  • Mosquito
  • Posts: 16
Progress! flexing elbows
« on: July 22, 2016, 11:35:30 PM »
The elbow seems to be a lot. I made a cap and it flexes wonderfully. The elbow has a LOT more going on. I have a lookup table in there and the sweep flexes based on a ratio.

Within the family, it works like a champ... which was my goal.

My next goal is to figure out how elbows recognize from the drawing that a 45 degree elbow is needed... or a 90 degree... and so on. :)

That may well mean that I have to start over and figure somethings out. But... hey, I am learning what I can't do. :)


Attached is where am so far if you are at all interested.  :mrgreen:
Revit MEP 2016
Revit 2017