Topic: Featureline from corridor problem

[ekoneo]

When I produce a featureline from corridor, why the featureline occures with vertical deviations like a saw teeth.
Corridor appearance is normal. But a featureline that crteated by that normal corridor, seem like a saw teeth.
Sometimes this problem occures sometimes not.

[mjfarrell]

many questions

what is your frequency settings for the region(s) where this happens?

is it in horizontal curve sections?

are you applying smoothing?

[ekoneo]

Frequency of the corridor is 2.5 m or 1m becouse of horizontal curves. Also vertical curve is exist.
To get the correct featureline, I tried creating the corridor with smooting and without smooting. Unfortunatelly I get the same results.
Why there is a relationship vertical or horizontal geometry and featureline shape?

[Dave20165]

Can you post a picture of this?

[mjfarrell]

can your create an assembly from only generic links to substitute for your current assembly?

I have a theory....

can you post a dwg of ONLY the assembly that is the source of the problem?

[ekoneo]

Thanks a lot.. I suspended the problem I will send the problem's photo and dwg of assembly after lunch break..

[ekoneo]

Interesting problem exist.
A corridor featurline is smooth. When I define this featureline as a target to another corridor, some deteriorations occure on the feature line.

I eleminate these deteriorations by using weeding. However, I update targeting corridore, that feature line goes wrong.

[mjfarrell]

there is a problem in the source....
perhaps break the link to the corridor for this feature line....it will allow editing
it wont be dynamic, hover you can get rid of the anomalies.

[econnerly]

Old thread... but have you tried putting the feature line on a different site? I've had this problem where it's reacting to another feature line I had that was frozen.