« previous next »
Pages: [1] |   Go Down

Author Topic: Linetype generation  (Read 1933 times)

0 Members and 1 Guest are viewing this topic.

ribarm

  • Gator
  • Posts: 3279
  • Marko Ribar, architect
Linetype generation
« on: November 09, 2013, 05:37:26 PM »
Maybe this isn't right forum for this question, but I don't know where to put it...

So question :
How to set ACAD to enable Linetype generation always while drawing 2d polylines?
Logged
Marko Ribar, d.i.a. (graduated engineer of architecture)

:)

M.R. on Youtube

Kerry

  • Mesozoic relic
  • Seagull
  • Posts: 11654
  • class keyThumper<T>:ILazy<T>
Re: Linetype generation
« Reply #1 on: November 09, 2013, 05:40:46 PM »
How about :
Plinegen=1
Logged
kdub, kdub_nz in other timelines.
Perfection is not optional.
Everything will work just as you expect it to, unless your expectations are incorrect.
Discipline: None at all.

ribarm

  • Gator
  • Posts: 3279
  • Marko Ribar, architect
Re: Linetype generation
« Reply #2 on: November 09, 2013, 05:45:18 PM »
Yes, that's it... In sysvdlg it was explained strange describing way how pline displays around vertices... So this variable is saved into DWG... I shell put it in my acaddoc.lsp to be always set to 1...

Thanks Kerry...
Logged
Marko Ribar, d.i.a. (graduated engineer of architecture)

:)

M.R. on Youtube
Pages: [1] |   Go Up
« previous next »