« previous next »
Pages: [1] |   Go Down

Author Topic: Look-up problem  (Read 3619 times)

0 Members and 1 Guest are viewing this topic.

Rabbit

  • Guest
Look-up problem
« on: October 01, 2012, 03:53:37 PM »
I've got a very complex dynamic block.  When I change the look-up to a different state, it takes two selections to get the dimension along the bottom to match what the look-up is set to.  Any ideas?

Any questions, I'll be glad to answer.

Rabbit
Logged

Krushert

  • Seagull
  • Posts: 13679
  • FREE BEER Tomorrow!!
Re: Look-up problem
« Reply #1 on: October 02, 2012, 10:17:04 AM »
Interesting, I see what you mean.  But I too am rustly at Look-Ups!
Logged
I + XI = X is true ...  ... if you change your perspective.

I no longer CAD or Model, I just hang out here picking up the empties beer cans

Rabbit

  • Guest
Re: Look-up problem
« Reply #2 on: October 02, 2012, 12:12:52 PM »
For the life of me, I can't figure out why it needs two selections to make it work.  It's a time saving like it is, but it's still a PITA.
Logged
Pages: [1] |   Go Up
« previous next »