Author Topic: Pipe End Break Symbol  (Read 7361 times)

0 Members and 1 Guest are viewing this topic.

M-dub

  • Guest
Pipe End Break Symbol
« on: December 02, 2004, 11:06:41 AM »
Has anyone got a routine that will draw a decent looking pipe break symbol?
Not two ellipses with one split in half...more like two teardrops with one split in half.  The one guy here insists on using two ellipses and it looks like garbage.  When I show him my way, he doesn't like it because it's "too hard".
I had a look on CADalyst, but couldn't find a decent one.
Thanks a lot!
Mike

hendie

  • Guest
Pipe End Break Symbol
« Reply #1 on: December 02, 2004, 11:41:56 AM »
check out www.resourcecad.com for the TUBEIT routine

don't you know you should look there first !  :twisted:

M-dub

  • Guest
Pipe End Break Symbol
« Reply #2 on: December 02, 2004, 11:43:30 AM »
Sorry Hendie, but I'm not a piper.  The piper is on vacation this week.  (Not that much more gets done when he IS here...:roll:)

Thanks for the tip.

M-dub

  • Guest
Pipe End Break Symbol
« Reply #3 on: December 02, 2004, 01:45:18 PM »
Thanks a lot, Hendie.
Tubeit worked out perfectly.  I'm going to make him a button so he uses it instead of his version from now on.

Thanks again! ;)

hendie

  • Guest
Pipe End Break Symbol
« Reply #4 on: December 02, 2004, 01:47:26 PM »
thanks, I'm glad it was what you were looking for

great site wasn't it ?

M-dub

  • Guest
Pipe End Break Symbol
« Reply #5 on: December 02, 2004, 02:00:51 PM »
'Twas!  I wonder who runs it!

There should be more links to it and reminders about it around here!  ;)

Keith™

  • Villiage Idiot
  • Seagull
  • Posts: 16899
  • Superior Stupidity at its best
Pipe End Break Symbol
« Reply #6 on: December 02, 2004, 04:43:05 PM »
Quote from: M-dub
'Twas!  I wonder who runs it!


DUH ....  I DUNNO
Proud provider of opinion and arrogance since November 22, 2003 at 09:35:31 am
CadJockey Militia Field Marshal

Find me on https://parler.com @kblackie