« previous next »
Pages: [1] |   Go Down

Author Topic: Insert * (filename)  (Read 2095 times)

0 Members and 1 Guest are viewing this topic.

Guest

  • Guest
Insert * (filename)
« on: October 05, 2007, 11:46:27 AM »
While I was going through some LSPs on my HD, I came across one that is similar to the following...

Code: [Select]
(command "insert" (strcat "*S:\\CADD\\......dwg") "0" "0" "")
So my question is this... what's the deal with the asterisk??  I don't think I've ever seen that one before.
Logged

Chuck Gabriel

  • Guest
Re: Insert * (filename)
« Reply #1 on: October 05, 2007, 11:50:35 AM »
It means to insert the block exploded.
Logged

Guest

  • Guest
Re: Insert * (filename)
« Reply #2 on: October 05, 2007, 11:53:42 AM »
Quote from: Chuck Gabriel on October 05, 2007, 11:50:35 AM
It means to insert the block exploded.

OOOOoooohhhhhhhhh.....


Thanks!
Logged

FengK

  • Guest
Re: Insert * (filename)
« Reply #3 on: October 06, 2007, 03:29:53 AM »
Quote from: Chuck Gabriel on October 05, 2007, 11:50:35 AM
It means to insert the block exploded.

Thanks Chuck, never knew about this one.
Logged

CADaver

  • Guest
Re: Insert * (filename)
« Reply #4 on: October 06, 2007, 11:33:31 AM »
Quote from: Kelie on October 06, 2007, 03:29:53 AM
Quote from: Chuck Gabriel on October 05, 2007, 11:50:35 AM
It means to insert the block exploded.

Thanks Chuck, never knew about this one.
Its been around longer than the EXPLODE command.

(booyah)
Logged
Pages: [1] |   Go Up
« previous next »