CAD Forums > CAD General
Trim using a block
VerticalMojo:
I cant find a way to trim using a block. I only have LT2000, is there a way? if not whats the best route to take?
Thanks fellow SwAmPeRs :)
hyposmurf:
Yeh if you had the complete version the BTRIM (express tool) would accomplish this.
VerticalMojo:
Well, what I came up with was a macro button.....
^C^Cbr;\f;
Its using the break command.......... If you are using full blown autocad, Ive noticed that you may need to add a ";" at the end (thats if you just wanted to try it, cause you got BTRIM lucky dawg)..... but it works fine with LT.
Kate M:
Isn't that the "Break at Point" button? (Modify toolbar)
Keith™:
Does LT have any of the express tools?
Navigation
[0] Message Index
[#] Next page
Go to full version