Well it is happening again right now. I can't see anything that is causing it, and it only is happening in the one drawing, and not every time. There is only one dxf code 1, so that isn't the issue. I edit it with code, and the new string doesn't show up when using ' entmod ' once. I even tried to ' entupd ' it, but that didn't make it show, as it is still in the drawing just not being shown. If I did another ' entmod ' to it, then it will show up. I'm kind of stumped, but will leave the drawing open to test other ideas. My other code that I changed to use ActiveX calls works though. I tried to see if it would show with a plot preview, but that didn't show the attribute info either. Here is the dxf code, I don't think it is any help though.
(-1 . <Entity name: 7ddf6518>)
(0 . "ATTRIB")
(330 . <Entity name: 7ddf6500>)
(5 . "6373")
(100 . "AcDbEntity")
(67 . 1)
(410 . "Layout1")
(8 . "E-ARTAG-NAM")
(100 . "AcDbText")
(10 29.0567 13.8875 0.0)
(40 . 0.09375)
(1 . "STORAGE")
(50 . 0.0)
(41 . 1.0)
(51 . 0.0)
(100 . "AcDbAttribute")
(2 . "%%URNAM")
(70 . 0)
(73 . 0)
(74 . 0)
(280 . 0)
Edit: After writing this, everything is working fine now. :realmad:
I'm totally lost on this one.