TheSwamp

CAD Forums => CAD General => The Third Dimension => Topic started by: Barry Clark on January 16, 2006, 09:46:23 PM

Title: Making an Eccentric Reducing Cone
Post by: Barry Clark on January 16, 2006, 09:46:23 PM

This one seemed to stump many....including myself. I found a guy who had a way of doing it on another forum and stripped his down to method that only takes a couple of minutes, never fails and you don't have to draw anything in WCS as his did.

I hope this helps!

Eccentric Reducer Cone video (http://www.theswamp.org/screens/Barry%20Clark/Eccentric%20Reducer%20Cone.wmv)

Title: Re: Making an Eccentric Reducing Cone
Post by: Barry Clark on January 16, 2006, 09:48:15 PM

Fairly large file size! Roughly 6mb!

Title: Re: Making an Eccentric Reducing Cone
Post by: Mark on January 17, 2006, 06:26:28 AM

Awsome Barry!

It's hard to beat a video when it comes to teaching. :-)

Title: Re: Making an Eccentric Reducing Cone
Post by: Barry Clark on January 17, 2006, 07:35:56 AM

Glad you dig it and, yeah, I like videos, too!