TheSwamp

CAD Forums => CAD General => Topic started by: Mark on September 09, 2005, 07:04:35 AM

Title: Question 25
Post by: Mark on September 09, 2005, 07:04:35 AM

Quote

What command would you use to apply the properties of a table cell to other table cells?

Title: Re: Question 25
Post by: Andrea on September 09, 2005, 06:30:04 PM

hmmmm...

cut & paste ?
 :-o

Have to look...I don't use table in AutoCAD..
does any one do ?

Title: Re: Question 25
Post by: Bob Wahr on September 09, 2005, 06:33:43 PM

Apparently not.  w00t!  I stumped the CAD Geeks.

Title: Re: Question 25
Post by: Keith™ on September 09, 2005, 07:52:44 PM

Well, since I don't use tables and cells (in fact you CAN'T use them in 2000/4) ... I am at a disadvantage ... but as soon as I migrate to 06, you can bet you ass I'll know the answer then ...

Title: Re: Question 25
Post by: MikePerry on September 10, 2005, 04:07:06 PM

_.MatchCell