TheSwamp
CAD Forums => CAD General => Topic started by: notredave on September 14, 2020, 10:18:26 AM
-
Good morning all,
Please see attached drawing. I edited block with BE. I changed all of my yellow test to layer text but when I use enhanced attribute editor, under properties, it still shows it on LEVEL 10. I want all yellow text on layer TEXT so I can purge LEVEL 10 but it's not working. Can someone take a look at drawing and let me know what the problem is? I would appreciate it.
Thank you,
Dave
-
Use ATTSYNC, select the block, purge the layer. Since you changed the layer of the attributes, you need to Sync the references to match the new properties.
-
That did the trick Jeff_M. Thank you very much.
-
Use ATTSYNC, select the block, purge the layer. Since you changed the layer of the attributes, you need to Sync the references to match the new properties.
I always recommend users 'send up the Bat Signal' when manipulating attributes. Gotta call BATTMAN to get the job done right.
-
Thank you for that bit of info dgorsman.