TheSwamp
CAD Forums => CAD General => Topic started by: Pukenzz on September 24, 2019, 03:58:27 PM
-
I’m looking for a dynamic block that is a call out bubble. Just a circle with an editable letter or number inside. I would like that block to function such that I can make the line coming off of it have an closed arrow, closed dot or nothing. I’d like it so that I can move the end of the line wherever I want it and the tail end always stays connected to the circle and points through the center. I can create it myself but before I spend the time, I thought I’d see if anybody already has one you can share or steer me towards.
Thanks in advance
-
Have you looked through the dynamic block forum? There may be something that you can use.
http://www.theswamp.org/index.php?board=56.0
-
here is a starter and modify to your needs
-
You could also create an mleaderstyle that uses the attributed 'circle' block.
-
The Annotation tab of the All Palettes Tool Palette may be a good place to start from.
-
You could also create an mleaderstyle that uses the attributed 'circle' block.
2nd that
The only reason I use the one attached earlier which mimics mleader is for callouts using sheetset manager otherwise I use mleaders