TheSwamp
CAD Forums => CAD General => Topic started by: Pepe on June 14, 2018, 12:07:41 PM
-
Is there any way to turn the 'orthomode dynamic info on screen' off? (Acad 2015)
I mean that little pale yellow rectangle by the crosshairs that shows "ortho: distance < angle" (I tried to post an image but don't know how)
Thnx.
-
Polar Tracking? If so F10 toggles it.
-
Polar Tracking? If so F10 toggles it
Thank you, Ronjonp, for a quick answer, but nope :thinking:: it only changes 'ortho' to 'polar' at the 'little pale yellow rectangle by the crosshairs', which still remains active...
-
F12 is dynmode or (setvar 'dynmode 0)
-
F12 is dynmode or (setvar 'dynmode 0)
Neither works :-( (i tried this the first).
I'm fearing that it is inherent to modes and it's not possible to turn it off... :no:
-
Type "options" on the command line then select the "dynamic input tab"
-
*SOLVED* ( :-))
Just subtract 32 from the value of AUTOSNAP system variable (32 = "Turns on tooltips for polar tracking, object snap tracking, and Ortho mode").
For instance, if its value is 55, just adjust it to 23.
Thanks to you all!