TheSwamp
CAD Forums => CAD General => Topic started by: Fabricio28 on March 30, 2015, 01:33:42 PM
-
Hi guys,
I'm working at the paperspace. I've already created a viewport, and I wanna create other viewport.
But When set a new viewport I'm get stuck in the coordinate 0,0,0.
Help me, please!
-
Huh? Upload a picture?
-
Is it locked ?
-
Thank you for the quick replay...
I'm not sure if the viewport is locked. How Can I unlocked?
-
Highlight it and look at the properties palette.
-
are LIMITS ON and Set?
is your OSNAP /GRID on and enabled thus causing you to snap to 0,0?
try draw rectangle first...then VPCLIP it into a viewport...
-
Hi Guys,
Take a look for me please...
-
turn off or change settings for SNAP mode
at present your paper size is smaller than SNAP increment
thus your viewport appears to remain @ 0,0
it would work if you used
Command: MV MVIEW
Specify corner of viewport or [ON/OFF/Fit/Shadeplot/Lock/Object/Polygonal/Restore/LAyer/2/3/4] <Fit>: Second thought probably NOT because SNAP increment is so LARGE
just turn off SNAP <F9>
-
turn off or change settings for SNAP mode
at present your paper size is smaller than SNAP increment
thus your viewport appears to remain @ 0,0
it would work if you used
Command: MV MVIEW
Specify corner of viewport or [ON/OFF/Fit/Shadeplot/Lock/Object/Polygonal/Restore/LAyer/2/3/4] <Fit>: Second thought probably NOT because SNAP increment is so LARGE
just turn off SNAP <F9>
:-D
Thank you very much!!
I didn't know what to do, you helped me a lot.
Thank you