TheSwamp
CAD Forums => Vertically Challenged => Topic started by: NirantarVidyarthee on September 21, 2013, 04:21:37 AM
-
I have inserted a part reference (AcadMech 2011). But I am not able to snap to the insertion point of it.
Doesn't the PartRef have snap point(s)?
Or am I missing something?
I am not a very experienced user of Acad mech.
The osnaps are on and all osnaps have been enabled.
-
OK.
I found the answer in an old post on another forum about similar problem. "AutoCad 2010 & AutoCad Mechanical 2010 Dimension Question".
"There is a filter to exclude dimensions in your Power Snap Settings, uncheck it."
In case of PartRef, uncheck the 'Symbol' in the filterlist.
Options > AM-Preferences > Snap Defaults > Filter Options