TheSwamp

CAD Forums => CAD General => The Third Dimension => Topic started by: Amsterdammed on September 04, 2013, 06:32:12 AM

Title: commands get wild with 3dsolids present
Post by: Amsterdammed on September 04, 2013, 06:32:12 AM

Hello there

i have some 3d solids in my dwg , they come form a revit model. some commands like "line" or "mirror" are taking for ever when i came in the neighborhood of some of those solids, ot looks like the osnap is trying to figure something out. Might take a few minutes for acad to came back out of the thinking mode. is this a known problem and what (if any ) is the solution, rather than freezing the layers with the solids?
 
Thanks Bernd

Title: Re: commands get wild with 3dsolids present
Post by: tedg on September 04, 2013, 12:12:14 PM

Quote from: Amsterdammed on September 04, 2013, 06:32:12 AM

Hello there

i have some 3d solids in my dwg , they come form a revit model. some commands like "line" or "mirror" are taking for ever when i came in the neighborhood of some of those solids, ot looks like the osnap is trying to figure something out. Might take a few minutes for acad to came back out of the thinking mode. is this a known problem and what (if any ) is the solution, rather than freezing the layers with the solids?
 
Thanks Bernd

Do you have a bunch of running osnaps that may be trying to snap to something on the solids?
If so, maybe try turning your running osnaps off (F3) and see if that helps?
 
 

Title: Re: commands get wild with 3dsolids present
Post by: Amsterdammed on September 05, 2013, 05:49:03 AM

nope even with the osnap off it does the same thing. i have no clue where this comes from. sometimes i have to about acad, i look in my autosave folder and if the last save was a not long ago, i rather get out of acad than wait forever till it comes back from thinking mode.